Build your own Ignition Cable (Red)
MSD Ignition Products
2 steps to a custom ignition cable
Reviews
Help others choose right. Be the first to write a review!
Write a reviewBuild your own ignition cable Red
Here you can build your own ignition cable in 2 simple steps. All ignition cables are made to order by Speeding.
Do you want a black ignition cable press here
- Custom-made for you
- Highest quality
- No hassle
- Ready to assemble
Step 1 - Choose cable fittings
Step 2 - Choose cable length
Done!
When you have received your ignition cable, you only need to fit the included ignition boots and that's it.
--------------------------------
More information:
Step 1 - (Choose cable fittings)
Choose which ignition cap you want versus spark plug and ignition coil/distributor.
There are two options, Male and Female.
Each variant is available as Straight, 45 or 90 degrees.
These are called different things on different sides.
SAE 6.5mm = HEI = Male
Used with spark plugs, distributors or ignition coils that have SAE 6.5mm connection
1. Straight
2. 45°
3. 90°
m4 = Socket = Pin = Female
Used with distributor or ignition coils with m4 connections
4. Straight
5. 45°
6. 90°
---------------------
Step 2 - (Choose cable length)
Choose the ignition cable length (cable length).
Please note that the total length may differ depending on the type of cable fittings used.
- Straight fitting + ~3cm
- 45° fitting + ~2cm
- 90° fitting + ~1cm
This product is made to order. No right of return.
----------------
Guides & Info
Be first to write a review about this product!
Your review:
To send a review, you must be logged in.
Associated products
Heat protection
Hurricane Ignition cable Heat protection 200x25mm - - Titanium-black
200x25mm / 1" ID × 8"
In stock
Hurricane Ignition cable Heat protection 200x30mm - Titanium-black
200x30mm / 1-1/4" ID × 8"
In stock
Hurricane Ignition cable Heat protection 200x30mm - Titanium
200x30mm / 1-1/4" ID × 8"
In stock
Suitable bracket
Tools
Ignition
